10/4/2023 0 Comments Schick 33 sensor calibration![]() In here you should see the remote firmware listed, along with the serial number and firmware for your sensor. If you do not, make sure that Eaglesoft/Patterson Imaging is closed and try the utility again. Go to the Start Menu on your computer, look for "CDRDicom For Windows" and then "CDR USB Remote HS Utility".If you need further assistance, please contact the Patterson Technology Center for further troubleshooting. ![]() Test the sensor, make sure that you are choosing an exam that was created for the sensors.For Hardware Type, in the drop-down box, please make sure that you have the "Elite Remote" listed. Click on the "Schick Sensor" button under Device Properties.Here you should have "Sensor" set as your default device and "Schick Sensor" set as your default sensor. Check preferences in Eaglesoft/Patterson Imaging under File | Preferences/General Preferences | XRay Tab.If you can get your remote and sensor information to show, please continue to step 4.If you are unable to get your equipment to recognize in the utility, your issue is most likely hardware related and you need to contact the Patterson Technology Center for assistance. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |